Interior painting in Sydney is a delicate and intricate process. Therefore, it is recommended to take your time while choosing the right colour combination and assessing the durability of each colour on its own. This guide will help you learn effective methods to create the perfect wall paint to complement your existing home decor.
Prepare the surface
It may seem obvious, but ensure that your walls are clean and dry before painting them. If you’ve been doing any DIY lately, remove all dust particles by vacuuming the entire surface area (it’s worth spending time here). Then wipe down with a damp cloth and let it dry thoroughly before moving on to step two.
Mask off areas that need protection
Paint can be slippery when it dries, so cover any areas you don’t want to get splattered with newspaper or masking tape – including light switches, electrical outlets, and any other fixtures that don’t want paint on them. Don’t forget to protect the floor too if there’s any risk of it getting dirty from splashes or drips!
Caulk wherever needed
Before you even start painting, make sure all the nails are pulled out of the wall and the holes are patched with putty. Then caulk any cracks or gaps in between wallboards. This will prevent dust from entering the walls while you’re painting, which can seriously affect how well your paint job turns out.
Sand down chipped areas
Once you’ve caulked everything up and patched any holes, you’ll want to sand down any chipped areas, so they look smooth when they’re painted over. You can use sandpaper for this step — make sure not to damage your drywall when doing so! It’s best to start with coarse sandpaper and then move on to finer grades until there aren’t any more chips left behind.
Use drop cloths
You can’t prevent all spills, but dropping clothes on the floor will help protect against drips, splatters, and smears. It also makes cleanup easier because you can simply throw away the drop cloth when you’re done.
Prime your walls
Priming is a very important part of the painting. It will help the paint stick better and last longer. You can either use a primer spray or roll on primer, depending on whether you’re using oil-based or water-based paint.
Paint your walls
Once you have primed your walls, you can now paint them. This step requires more time than everything else combined, as it requires you to take your time while painting so that you don’t miss any spots that might need more attention. Make sure not to rush through this step because rushing will result in sloppy workmanship and poor quality results!
Buy a lot of painter’s tape.
The best way to paint is to tape off anything you don’t want to paint. This includes corners and edges, as well as moulding and trim. It will save you time for long because you won’t have to go over certain areas repeatedly. After all, they got painted by mistake. So make sure you buy enough tape for your project!
Paint around the outlets and light switches
If you have a light switch that is close to the wall, consider moving it. If this is not possible, you can paint around it. This will make your new colour scheme look better and make sure that it blends in with the rest of the room.
Interior painting in Sydney is a simple and relatively easy task, but if you don’t follow the right steps or take proper care, it can turn into a very annoying experience. Therefore, when you are planning to paint the inside of your home (as opposed to a single room or fence), you need to be prepared.